BOXER KING 5600 - Page 77

Service Manual 04/2010 Rev.B
77
Fig.133
Fig.134
 To dismount the cabinet tool holder on the
King 5600 remove the 14mm nut in Fig.135
and then that one of 20mm in Fig.136.
NOTE: SOMETIMES THERE ARE SHIMS
BETWEEN CABINET AND NUT. THESE SHIMS
MUST BE PLACED AGAIN IN THE SAME
POSITION.
Fig.135
Fig.136
 To dismount the cabinet tool holder on the
King 5600 remove the 14mm nut in Fig.137
and then those ones of 10mm in Fig.138.
Fig.137
Fig.138