47
4. Entering and Editing Text/Symbols
To apply the properties of the current tag to ALL or multiple tags:
1. Enter [Fn] + [File] > “Apply Current Tag Settings”.
The Apply Current Tag Settings submenu appears.
2. Select “All Tags” or “Set Range” (and enter the range of
selected tags) AND press [OK].
If data loss may occur, a warning message will appear,
asking for your confirmation to continue.
3. Press [OK].
Once the change is completed, the screen returns to the Tag
Editor.
To save the current properties as the default for subsequent tag
editing:
1. Enter [Fn] + [File] > “Default Settings”.
The Default Settings submenu appears.
2. Select “Save Current Tag as Default” and press [OK].
A warning message appears, asking for your confirmation to
save the current tag properties as the default tag settings.
3. Press [OK].
The screen returns to the Tag Editor.
To Next Page
Loading...
