English
82
6. Maintaining Your Printer
G. Replacing the Ribbon Cartridge
1 Pull the cover latch and open the printer cover.
Within the printer, near the bottom right hand corner, you
should be able to find the ribbon cartridge.
2 Check that the printer ribbon is not trapped between the
printhead and the platen roller.
If it is and the printer is on, press the [Maintain] quick key to
to home the printhead.
If the printer is off, switch it on and the printhead should home
automatically.
3 Grasping the finger tab of the old ribbon cartridge, pull the
cartridge up, as shown in the diagram below.
4 Grasping the finger tab of the new ribbon cartridge, insert the
cartridge with its label facing up, as shown in the diagram
above.
5 Ensure that the printer ribbon is right over the printhead and
push the cartridge slightly to snap into place.
6 Close the cover firmly so that you can hear and feel that it
latches.
To clear the printhead area of used ribbon, turn the top
spool of the ribbon counterclockwise.
To Next Page
Loading...
