Bresser Rex II - Starting the Printer; Inserting the Filament

www.bresser.de
32
4.2 Starting the printer
4-3
(4-3) Plug the power cord into the connector (B) on the back of the printer. Insert
the Euro plug into the mains power socket. Move the on/off switch (A) to position
'I' to switch on the unit.
4.3 Inserting the filament
The filament guide tube must be inserted correctly so that the filament is stuck
and the device is not damaged.
4-4
(4-4) Slide the filament out of the filament detection element through the filament
guide tube.