Bresser Rex II - Printing from USB Flash Drive

www.bresser.de
75
● Click the [Print] button . The computer transfers the Gcode file to the printer.
● After the transmission is completed, the printer warms up automatically. When
the warm-up is completed, the printer starts to create the model.
7.2.3 Printing from USB flash drive
① Insert the USB flash drive containing the desired G or GX file into the 3D
Printer.
② Turn on the 3D printer. Make sure that the height of the pressure plate is
adjusted accordingly and filament is inserted.
③ Touch [Print], and then touch the SD Card icon in the centre. The file(s) are
displayed on the touch screen. Select the desired file and press [Print]. The file
is transferred to the printer.
⑥ The printer automatically starts the nozzle warm-up process and printing
starts when the nozzle reaches the specified temperature.
Abort: To stop the warm-up process and printing. When you press [Abort], the
operation is canceled permanently.
Pause: To stop the print job, tap again to resume. This function is useful when
you want to change the filament during the print job.