www.bresser.de
2) Others
A Extrusion ratio: The amount of filament discharged from the extruder. Default:
Max. 125 % (The standard ratio is recommended)
b. Path Width: The width of the path, the default value is set to 0.4 mm. It is
recommended to keep the default value.
C Path resolution: The default value is set to 0.1 mm. The higher the value, the
lower the resolution of the job. Conversely, a lower value leads to a higher
resolution of the order.
Others
1) Dimensional Adjustments
A Enable Adjustments: If you activate this option, the software can make error
adjustments.
b. External Compensation: If you activate this option, the software can make
adjustments for outer diameter errors.
8-8
To Next Page
Loading...
