www.bresser.de
extruder before the engine is started.
NOTE:
Do not start operation before the extruder temperature has reached the
filament pressure temperature.
When using PLA filament, the extruder temperature should be 200℃. When the
extruder temperature is reached, click the [Forward]/[Reverse] buttons to
control the insertion/removal of filament. If you want to stop inserting or
removing filament, you can click the [Stop] button.
● Temperature Controls: Enter the desired temperature in the left field and
click on [Apply]. The printer automatically heats the corresponding part. On the
right side the current temperature of the respective part is displayed. After the
heating process has started, the shape of the temperature curve shown below
changes and the different colours represent the temperatures of the respective
parts.
② Update firmware
Each time REXprint is started, it automatically checks for a newer version of the
firmware and then downloads it. If an update is available, a pop-up window
informs the user about the available update.
Step 1: Click at [Tools] > [ Update firmware]. Before updating the firmware, all
existing connections must be terminated. If the software and the printer are
already connected, you will be reminded that the connection must be terminated.
Select [Yes] and proceed to the next step.
To Next Page
