www.bresser.de
b. Space to Model: The maximum distance between the pre-applied filament
and the first model layer.
C Path Length: The filament length for the pre-order.
D Speed: The print speed for the pre job.
3）Wall
A Enable Wall: Enable this option to allow the extruder to print a wall during the
printing process. By activating the wall function, thread pulling or swelling can
be prevented to a certain extent.
b. Shell Count: To control the number of compression rounds for the envelope
of the supports.
C Space to Model: The minimum distance between the wall and the model.
D Speed: The speed at which the wall is printed.
To Next Page
Loading...
