FT800 Series Programmer Guide
Version 2.1
Document Reference No.: BRT_000030 Clearance No.: BRT#037
251
Product Page
Document Feedback Copyright © Bridgetek Limited
Register Definition 83 REG_CTOUCH_TOUCH4_Y Definition
Note: This register is only applicable in the extended mode
REG_CTOUCH_TOUCH4_Y Definition
Bit 0 - 15 : The value of these bits are the Y coordinates of the fifth touch point.
REG_CTOUCH_TRANSFORM_A Definition
REG_CTOUCH_TRANSFORM_A has the same definition with REG_TOUCH_TRANSFORM_A.
See REG_TOUCH_TRANSFORM_A for more details
REG_CTOUCH_TRANSFORM_B Definition
REG_CTOUCH_TRANSFORM_B has the same definition with REG_TOUCH_TRANSFORM_B.
See REG_TOUCH_TRANSFORM_B for more details
REG_CTOUCH_TRANSFORM_C Definition
REG_CTOUCH_TRANSFORM_C has the same definition with REG_TOUCH_TRANSFORM_C.
See REG_TOUCH_TRANSFORM_C for more details
REG_CTOUCH_TRANSFORM_D Definition
REG_CTOUCH_TRANSFORM_D has the same definition with REG_TOUCH_TRANSFORM_D.
See REG_TOUCH_TRANSFORM_D for more details
REG_CTOUCH_TRANSFORM_E Definition
REG_CTOUCH_TRANSFORM_E has the same definition with REG_TOUCH_TRANSFORM_E.
See REG_TOUCH_TRANSFORM_E for more details
REG_CTOUCH_TRANSFORM_F Definition
REG_CTOUCH_TRANSFORM_F has the same definition with REG_TOUCH_TRANSFORM_F.
See REG_TOUCH_TRANSFORM_F for more details
Note: Calibration should only be performed in compatibility mode (default), in the same
way as with resistive displays.
To Next Page
Loading...