2-8
GF Series
Installation and Operation Manual
X-TMF-GF Series-MFC-eng
Part Number: 541B137AAG
March, 2010
Section 2 Product Descripton
2-8 Optional Features
Optional features are set at the factory to customer requirements. Basic
optional features are described below. Refer to Appendix A for further
details.
2-8-1 Control Valve Options
The GF1XX is configured at the factory to be Normally Closed or Normally
Open. This configuration can not be modified by the user and must be
selected when the order is placed.
2-8-2 Flow Direction Option
GF1XXs are only available in the standard configuration where the sensor
is upstream and the valve is downstream.
2-8-3 Fittings Option
GF1XXs use downported fittings or conventional ¼" VCR® fittings.
2-8-4 I/O Communication
The GF1XX interfaces to DeviceNet or analog/RS485 protocols.
2-8-5 Cable Connector Options
GF1XXs use a 5-pin male connector (M12) that connects to the DeviceNet
cable, or a 9-pin "D" male connector (UDG9) that connects to an analog/
RS485 cable. Connector pin-out details are shown in Appendix D.
To Next Page
