Home > Troubleshooting > Error and Maintenance LEDs
Error and Maintenance LEDs
Related Models: ADS-1300/ADS-1350W
The LED indicators on the control panel are explained in this table.
If there is an error that you cannot clear yourself, contact your Brother dealer or Brother Customer Service.
Error Indicator
Power Indicator Description
The LED is off.
The LED is on.
The LED is flashing.
When (USB LED) is off.
Error
Indicator
Power
Indicator
Machine Status
Firmware update error
This machine cannot boot. Go to your model's Downloads page at
support.brother.com/downloads, and then download and install the latest firmware.
Document Jam
Clear the document jam. If scanning a long document, select Long Paper from the
Scan Size or Document Size drop-down list.
Pick Up Document Error
The machine cannot pick up the document. Open the Front Cover and remove the
document. Close the Front Cover and reload your document.
Front Cover Open
The Front Cover is open.
Access Error (Scan to PC)
• The USB cable is not connected to the machine. Connect the USB cable.
• (ADS-1350W) If your machine is connected via a network, you must configure
the Scan Destination setting using Web Based Management.
Feed Selector is set incorrectly, or the ADF and the Card Slot are both loaded
with a document and a card.
• Set the Feed Selector to the left side when scanning from the ADF, and to the
right side when scanning from the Card Slot.
• Load either the ADF or the Card Slot, whichever one you want to scan from.
Plastic Card Jam
Clear the card jam. If you inserted an embossed card, make sure to insert it
embossed side up, into the Card Slot.
Memory Full
214
To Next Page
Loading...
