Brother ADS-1300 - Configure Scan to Workflow Settings Using Brother iPrint&Scan

Home > Scan > Scan Using Brother iPrint&Scan (Windows/Mac) > Configure Scan to Workflow Settings
Using Brother iPrint&Scan
Configure Scan to Workflow Settings Using Brother iPrint&Scan
The following conditions must be satisfied to use Scan to Workflow:
• Windows
- The scanner driver is installed.
Download and install the driver at
support.brother.com/downloads.
- Default settings have been configured for scanning from the machine.
Configure the settings by following the on-screen directions in the Machine Scan Settings screen.
• Mac
- iPrint&Scan Push Scan Tool is installed.
Download and install the iPrint&Scan Push Scan Tool at
support.brother.com/downloads.
- Default settings have been configured for scanning from the machine.
In the Brother iPrint&Scan home screen, click Machine Scan Settings > Select folder..., and save
where applicable. Complete the process by following the on-screen instructions.
>> Create a Workflow
>> Configure Workflows
>> Edit or delete the Workflow
Create a Workflow
1. In the Brother iPrint&Scan home screen, click Create Workflow.
2. Create a workflow by following the on-screen instructions.
If you want to scan from your machine, check the Set this workflow. It can be started from the control
panel of your machine. checkbox before clicking the Save button.
Configure Workflows
1. In the Brother iPrint&Scan home screen, click Machine Scan Settings > Workflow.
2. Select the workflow you want to display when the Workflow button is pressed on the machine, and click OK.
Edit or delete the Workflow
1. In the Brother iPrint&Scan home screen, click
Application Setting > Workflow Management.
2. Select the workflow you want to edit or delete, and click either Edit or Delete.
Related Information
• Scan Using Brother iPrint&Scan (Windows/Mac)
Related Topics:
• Save Scanned Documents Using Scan to Workflow Function
83