Brother HL-4040CN - Page 59

Wireless configuration for Windows
®
using the Brother automatic installer application
52
4
Note
• If a message to restart your computer appears after the wireless settings have been changed, restart your
computer and then go back to step c and continue with the install skipping steps i, j and k.
• For Windows
®
XP SP2 users:
You can temporarily change the wireless settings on your computer, following the steps below:
1 Click Start and then Control Panel.
2 Click Network Connections icon.
3 Select and right click Wireless Network Connection. Click View Available Wireless Networks.
4 You can see the Brother wireless printer in the list. Select SETUP and click Connect.
5 Check the Wireless Network Connection status. It may take a few minutes to change from 0.0.0.0.
to 169.254.x.x IP address to be shown on screen (where x.x. are numbers between 1 and 254).
l If more than one wireless printer is available on the network, the following list appears. If the list is blank,
check if the access point and the printer are powered on, and then click Refresh. Choose the printer you
wish to configure, and click Next.
Note
The default Node name is “BRNxxxxxx” for the users that temporary connect with a network cable, or
“BRWxxxxxx” for the users that connect without a network cable (where “xxxxxx” are the last six digits of
Ethernet address).