CHAPTER 4 TROUBLESHOOTING
Confidential
4-66
8.4 Wireless Network Troubleshooting
<Wireless setup problems>
The Brother print server is not found during setup using the automatic installer application on
the CD-ROM.
1. Make sure that the printer is powered on, is on-line and ready to print.
2. Move your Brother printer closer to the computer and try again.
3. Reset the print server back to its default factory settings and try again. For the information
how to reset to the factory default settings.
<Wireless connection problem>
The wireless network connection is sometimes disabled.
The wireless network connection status is affected by the environment where the Brother
printer and other wireless devices are located. The following conditions may cause connection
problems:
- A concrete or metal framed wall is installed between the Brother printer and the access point.
- Electric appliances such as televisions, computer appliances, microwave ovens, intercoms,
mobile/cellular phones and the battery chargers and AC power adapters are installed close to
your network.
- A broadcast station or high-tension wire is located close to your network.
- A fluorescent light is being switching ON or OFF.
To Next Page
Loading...
Need help?
General