CHAPTER 7 SERVICE SUPPORT SOFTWARE
Confidential
7-2
NOTE:
* Each mode starts 2 seconds after pressing the Go button.
* Both “Network Factory Reset 1” and “Network Factory Reset 2” functions are not
available for HL-5240.
Explanation of functions of each Users Mode is shown below.
< Functions of each “Users Mode” >
(1) Test Sample Page
The printer prints a demo page. The printer returns to the ready status after printing.
(2) Print Fonts
The printer prints a list of the internal fonts. The printer returns to the ready status after
printing.
(3) Hex Dump Mode
You can print data as hexadecimal code. To exit from this mode, you have to turn off the
printer.
(4) PCB ONLY Mode
Even when the engine error occurs and PCB exchange is required for recovery, the
printer can be started, ignoring the engine error if this mode is used. NVRAM data can be
obtained.
(5) 1push Printing Recovery Mode
Demo page print is possible by pressing Go button after the power supply is turned on.
(6) Network Factory Reset 1 (APIPA: ON)
The network setting is reset to its factory setting. (APIPA is ON)
(7) Network Factory Reset 2 (APIPA: OFF)
The network setting is reset to its factory setting. (APIPA is OFF)
(8) NV-RAM Factory Reset
The printer is restored to the factory setting and permanent fonts and macros are cleared.
The printer returns to the ready status after printing.
To Next Page
Loading...
Need help?
General