Brother MFC-9010CN - Using the BR-Script3 Driver (Postscript 3 Language Emulation Printer Driver)

Printing and Faxing
125
7
Using the BR-Script3 Driver
(PostScript
®
3™ language emulation printer driver) 7
Note
• To use the BR-Script3 printer driver, you need to set the Emulation to BR-Script 3 by using the
control panel before connecting the interface cable. (See Printer Emulation Support on page 110.)
• The BR-Script3 printer driver does not support the PC-Fax Sending.
• For network users, see the Network User’s Guide for installation steps.
You need to install the BR-Script3 printer driver using the following instructions.
Note
If you use a USB cable and Mac OS, only one printer driver for a machine can be registered in
Printer Setup Utility (Mac OS X 10.3.9 to 10.4.x) or Print & Fax in System Preferences (Mac OS X
10.5.x). If a Brother Laser driver is already listed in the Printer list, you will need to remove it and then install
the BR-Script3 printer driver. For the information about removing the printer driver, see Removing the
Printer driver for Macintosh on page 124.
 (Mac OS X 10.3.9 to 10.4.x)
a Choose Applications from the Go menu.
b Open the Utilities folder.