Brother P-touch PT-D600 - Adjusting the Label Length; Printing from the Label Collection; Printing a Label from the Label Collection Stored in the P-Touch

LABEL PRINTING
47
Adjusting the Label Length
Adjusting the Label Length
When the tape cassette comes to the end, the printed length may be less
accurate.
In this case, you can adjust the label length.
NOTE
Adjusting Label Length by 1 level increases total label length by
approximately 1 %.
Printing from the Label Collection
 Printing a label from the label collection stored in the P-touch
特別色帶
• Select this setting when using special
tape.
• When using Fabric Tapes, or Heat
Shrink Tube, select [ 特別色帶 ] for
Cut Options before printing. After
printing, remove the tape cassette
from the P-touch and use scissors to
cut the tape.
• When multiple copies
are printed one time:
• When a label is printed
two times:
1. 1st print
2. 2nd print
Setting Description Example
ABC
ABC ABC
24.5 mm 4 mm 4 mm
ABC ABC
12
24.5 mm
26.5 mm
()  / [設定 ]  ( ) or ( )  / [長度微調 ] 
( ) or ( )
 / [-3 - +3]  ( ) or ( ).
()  / [標籤集 ]  ( ) or ( )  / Select a category
 () or ( )  / Select a label  ( ) or ( )
Check the label image  () or ( )  / [列印]  () or
()
 / Select the number of copies  (), () or
().