Brother RJ-3230B - Page 141

• Enable this address
Enables the specified static IPv6 address.
• Primary DNS Server IPv6 Address/Secondary DNS Server IPv6 Address
Specifies the DNS server IPv6 addresses.
• IPv6 Address List
Displays the list of IPv6 addresses.
Wired 802.1x Authentication
Configures IEEE 802.1x authentication.
• Wired 802.1x Status
Enable or disable IEEE 802.1x authentication for wired networks.
• Authentication Method
Select the authentication method.
• User ID/Password
Specify these settings only when EAP-MD5, EAP-FAST, PEAP, EAP-TTLS, or EAP-TLS is selected as the
authentication method. In addition, with EAP-TLS, it is not necessary to register a password, but a client
certificate must be registered. To register a certificate, connect to the printer from a web browser, and then
specify the certificate. Installation of the authentication certificate can also be performed with the Printer
Setting Tool by going to the menu bar: File > Install Certificates.
Wireless Settings
• Communication Mode
Displays the available communications modes.
• SSID (Network Name)
Clicking Search displays the available SSIDs in a separate dialog box.
• Channel
Displays the automatically selected channel.
• Authentication Method/Encryption Mode
The supported encryption modes for the authentication methods are shown in the table below.
Authentication Method
Encryption Mode
Open System None / WEP
Shared Key WEP
WPA3-SAE AES
WPA/WPA2-PSK/WPA3-SAE TKIP+AES / AES
EAP-FAST/NONE TKIP+AES / AES
EAP-FAST/MS-CHAPv2 TKIP+AES / AES
EAP-FAST/GTC TKIP+AES / AES
PEAP/MS-CHAPv2 TKIP+AES / AES
PEAP/GTC TKIP+AES / AES
EAP-TTLS/CHAP TKIP+AES / AES
EAP-TTLS/MS-CHAP TKIP+AES / AES
EAP-TTLS/MS-CHAPv2 TKIP+AES / AES
EAP-TTLS/PAP TKIP+AES / AES
EAP-TLS TKIP+AES / AES
137