Home > Appendix > Optional Accessories > Charging Cradle (Optional: PA-CR-005) > Charge the Battery
Using the Charging Cradle
Charge the Battery Using the Charging Cradle
The Charging Cradle (PA-CR-005) cannot recharge the printer's battery without being connected to an electrical
socket using the AC Adapter (PA-AD-600A).
>> Before Charging the Battery
>> Charge the Battery
>> Remove the Printer from the Charging Cradle
>> Lock the Eject Button
Before Charging the Battery
1. Remove the Charging Cradle terminal cover with a flathead screwdriver.
2. Install the Charging Cradle Terminal Attachment onto the printer using the Charging Cradle Terminal
Attachment and screws included with the Charging Cradle.
Make sure the notched corner is aligned correctly.
Charge the Battery
1. Connect the AC Adapter to the Charging Cradle's DC Connector.
2. Connect the AC power cord to the AC Adapter.
3. Connect the AC power cord to a nearby electrical socket.
4. Align the Charging Cradle Terminals of the Charging Cradle and the printer.
5. Press the printer down and onto the Charging Cradle until the latches lock it firmly in place.
The printer’s LED Indicator lights in orange when charging.
202
To Next Page
Loading...
