Brother RJ-3230B - Connect the Printer to a Wired LAN Network via 4-bay Charging Cradle

Home > Appendix > Optional Accessories > 4-bay Charging Cradle (Optional:PA-4CR-003) > Connect the
Printer to a Wired LAN Network via 4-bay Charging Cradle
Connect the Printer to a Wired LAN Network via 4-bay Charging Cradle
Use an Ethernet (LAN) connection to configure your printer and upgrade its firmware.
NOTE
Make sure that the Ethernet (LAN) cable is fully inserted in the Ethernet (LAN) Port.
LED Indicators
1 2
1. Ethernet (LAN) LED
LED Indicator
Status
Ethernet (LAN) not connected
Ethernet (LAN) connected
Receiving or sending data via Ethernet (LAN)
2. Status LED
LED Indicator
Status
The printer is placed on the 4-bay Charging Cradle and the battery is fully charged.
The printer is charging on the 4-bay Charging Cradle.
Interface Compatibility
Use the [WLAN] and [Wired LAN] menus to select WLAN, Wired LAN, or no connection when the printer is on
the 4-bay Charging Cradle.
Cradle LAN Setting
WLAN Setting Connection type when using the 4-bay Charging Cradle
On On
WLAN →Wired LAN
1
On Off
No connection enabled →Wired LAN
Off On WLAN
Off Off
No connection enabled
1
Wireless Direct function is not affected.
212