Brother RJ-3230B - Connect the Printer to a Wired LAN Network via Charging Cradle

Home > Appendix > Optional Accessories > Charging Cradle (Optional: PA-CR-005) > Connect the Printer
to a Wired LAN Network via Charging Cradle
Connect the Printer to a Wired LAN Network via Charging Cradle
Use an Ethernet (LAN) connection to configure your printer and upgrade its firmware.
NOTE
Make sure that the Ethernet (LAN) cable is fully inserted in the Ethernet (LAN) Port.
LED Indicators
2 1
1. Ethernet (LAN) LED
LED Indicator
Status
Ethernet (LAN) not connected
• Ethernet (LAN) connected
• Receiving or sending data via Ethernet (LAN)
NOTE
The Ethernet (LAN) LED does not light up unless the printer is placed on the Charging Cradle.
2. Status LED
LED Indicator
Status
The printer is placed on the Charging Cradle and the battery is fully charged.
The printer is charging on the Charging Cradle.
Interface compatibility
Use the [WLAN] and [Wired LAN] menus to select WLAN, Wired LAN, or no connection when the printer is on
the Charging Cradle.
Cradle LAN Setting
WLAN Setting Connection type when using the Charging Cradle
On On
WLAN →Wired LAN
1
On Off Wired LAN
1
Wireless Direct function is not affected.
204