Brother RJ-3230B - Load the Roll

Home > Set Up Your Printer > Load the Roll
Load the Roll
>> Load the Roll
>> Change the Media Roll Holders to Use Custom-Size Media
>> Use the Roll Holder Stop
>> Tear-Off Media
Load the Roll
1. Push the Roll Cover Release Lever to open the Roll Compartment Cover.
a
a. Roll Cover Release Lever
2. Slide both Roll Guides outwards.
3. Make sure that the roll is correctly aligned, and then insert it into the Roll Compartment.
NOTE
If the core of the roll is protruding, flatten the edges before setting, as illustrated.
a
a. Print surface (faces outwards on the roll)
4. Close the Roll Compartment Cover until it locks into place.
25