Brother RJ-3230B - Install the Label Peeler

Home > Appendix > Optional Accessories > Label Peeler (Optional: PA-LP-007) > Install the Label Peeler
Install the Label Peeler
This printer is compatible with the Label Peeler (PA-LP-007).
Parts Description
Label Peeler Assembly
Screws (2 each)
1. Push the Roll Cover Release Lever to open the Roll Compartment Cover.
a
a. Roll Cover Release Lever
2. Remove the standard platen and holder unit by removing the four screws shown in the illustration.
CAUTION
• Do not touch the blade when removing the standard platen.
• Do not touch the tear bar when removing the holder unit.
Recommended tightening torque: 0.55±0.049 N·m.
3. Install the platen and holder unit, and fasten them using the four screws supplied with the Label Peeler.
193