Brother RJ-3230B - Mount the 4-bay Charging Cradle on the Wall

Home > Appendix > Optional Accessories > 4-bay Charging Cradle (Optional:PA-4CR-003) > Mount the 4-
bay Charging Cradle on the Wall
Mount the 4-bay Charging Cradle on the Wall
1. Drill four holes in a commercially available board according to the spacing of the screw holes of the 4-bay
Charging Cradle.
b
a
a. Height: 61 mm
b. Width: 406.4 mm
2. Affix the Charging Cradle to the board using four screws, as shown in the illustration.
• Make sure you install the Charging Cradle in the correct direction so that the printer will not fall.
• Use M5 size screws.
3. Lean the board against the wall or secure the board to the wall.
Related Information
• 4-bay Charging Cradle (Optional:PA-4CR-003)
214