Home > Appendix > Optional Accessories > 4-bay Charging Cradle (Optional:PA-4CR-003) > Charge the
Battery Using the 4-bay Charging Cradle
Charge the Battery Using the 4-bay Charging Cradle
The 4-bay Charging Cradle cannot recharge the printer's battery without being connected to an electrical socket
using the AC adapter (PA-AD-600A).
>> Before Charging the Battery
>> Charge the Battery
>> Remove the Printer from the Charging Cradle
Before Charging the Battery
1. Remove the Charging Cradle terminal cover with a flathead screwdriver.
2. Install the Charging Cradle Terminal Attachment onto the printer using the Charging Cradle Terminal
Attachment and screws included with the Charging Cradle.
Make sure the notched corner is aligned correctly.
Charge the Battery
1. Connect the AC Adapter to the Charging Cradle's DC Connector.
2. Connect the AC power cord to the AC Adapter.
3. Connect the AC power cord to a nearby electrical socket.
4. Align the Charging Cradle Terminals of the Charging Cradle and the printer.
210
To Next Page
Loading...
