5. Insert the roll. For more information, , see Related Topics..
6. Close the Roll Compartment Cover and press until it locks into place.
7. If the LCD automatically shows [Select Media] or [Auto Detect], select the option you want. To
configure these settings later, go to the [Media] menu
Use the Roll Holder Stop
The Roll Holder Stop prevents the Roll Guides from closing. It is ideal to reduce the distance needed to extend
the Roll Guides to load the roll.
1. Remove the backing paper from the two locations on the Roll Holder Stop, as shown in the illustration.
2. Extend the Roll Guides outward and attach the Roll Holder Stop to the innermost part of the groove.
• The Roll Holder Stop is compatible with the 76 mm roll width.
• Attach the Roll Holder Stop with the Roll Guides extended outward.
• The Roll Holder Stop can be attached to either side of the groove.
• Attach the Roll Holder Stop to prevent surplus air from accumulating between the adhesive layer and
the printer.
• Clean the pasted part of the printer before attaching.
Tear-Off Media
Receipt paper, labels, and tags can be torn off by swiftly pulling up or down on the media according to the set
cutting position. Linerless media can only be torn upwards.
27
To Next Page
Loading...
