Brother RJ-3230B - Page 207

• The printer’s LED Indicator will turn off when charging is complete.
Remove the Printer from the Charging Cradle
• Push the Eject Button on the back of the Charging Cradle, lift the printer, and then remove it from the
Charging Cradle.
1
1. Eject Button
Lock the Eject Button
• Insert a cotter pin (or similar) through the hole as illustrated below.
Use a Low Carbon Steel Extended Prong Retaining Cotter Pin (not included): Length: 50 mm, Pin
Diameter: 2 mm
1
2
2
1. Diameter: 2.3 mm
2. Length: 41.2 mm
To purchase the Cotter Pin, contact your local Brother dealer.
Related Information
• Charging Cradle (Optional: PA-CR-005)
203