S-7300A
5. USING THE OPERATION PANEL (BASIC OPERATIONS)
5-5. Using program individual functions and program common functions
・ In addition to start backtack sewing, main sewing and end backtack sewing, the following 9 types of functions are also
included in the parameters which are necessary for sewing.
Needle up/down, thread trimming lock, thread wiping, correction sewing, AUTO, slow start, special locus, best PFM mode,
auto X-over seam assist mode.
・ Of these 9 types of functions, the functions which can be set separately for each program are called "program individual"
functions.
* When an assignment is made to a program individual function, a "P" symbol appears in the top-left corner of the icon.
On the other hand, the functions which can be set in common for all programs (P1 to P9) are called "program common"
functions.
・ Each of the 9 types of functions can be set to be used as either a program individual function or a program common
function. (Memory switches MSW-301 to MSW-309)
At the time of shipment from the factory, the settings are as follows.
Program individual
functions
Program common function
Needle up/down
× ○
Thread trimming lock
× ○
Thread wiper
× ○
Correction sewing × ○
AUTO ○ ×
Slow start × ○
Special locus
○ ×
Best PFM mode
○ ×
X-over seam assist mode
○ ×
To Next Page
Loading...
