MAINTENANCE SCHEDULE (2-STROKE)
EVERY 6 000 KM (4,000 MI) OR 2 YEARS
(WHICHEVER COMES FIRST)
ENGINE
Clean and lubricate rewind starter
Inspect fuel pump strainer and replace if necessary
FUEL
SYSTEM
Inspect throttle cable
Replace brake fluid
Lubricate the splines of joint between QRS axle and gearbox (XU
models)
Lubricate the spline s of joint between driven p ulley and QRS axle (XU
models)
DRIVE
SYSTEM
Replace the following drive pulley wear parts: slider shoes, O-rings
and sliding sheave bushing (E-TEC)
FRAME
Retighten rear member screws to frame to specified torque (XU)
24 N•m (18 lbf•ft)
EVERY 10 0 00 KM (6,000 MI) OR 3 YEARS
(WHICHEVER COMES FIRST)
E-TEC: Inspect oil pump strainer an d clean if needed
ENGINE
Clean 3D rave valves
DRIVE
SYSTEM
Replace the following drive pulley wear parts: spring cover bushing
and ramps (E-TEC)
ELECTRICAL
SYSTEM
E-TEC: Replace spark plugs
EVERY 5 YEARS
ENGINE
Replace engine coolant
FUEL
SYSTEM
Replace in-line fuel filter (E-TEC)
_______________
99
To Next Page
Loading...
