BRP Lynx Commander 600 E-TEC - 15 Passengers Handholds (if Equipped)

CONTROLS, INSTRUMENTS AND EQUIPMENT
Passenger Seat Removal
To remove the passenger seat, pro-
ceed as follo ws:
1. Push the latch tab in and lift-up the
rear of seat.
mmo2009-004-017_a
Step 1: Push tab
Step 2: Lift rear of seat
2. Slide seat rearward and set aside.
Passenger Seat Installation
To install the passenger seat, proceed
as follows:
1. Place the passenger seat facing for-
ward on the storage box lid.
2. Slightly incline the passenger seat
towards front and engage both seat
hooks in the storage box lid slots.
mmo2009-004-018_a
1. Seat ho ok
2. Slot
3. Push the passenger seat to
wards
the driver's seat and firmly push the
rear portion down to lock the pas-
senger seat in position
.
CAUTION When closing lid
with the passenger seat i nstalled,
secure with the retaining strap.
NOTE: A distinctiv e snap will be felt.
Double check that the seat is secure by
giving it a tug to confirm proper latch-
ing.
WARNING
Make sure seat is securely latched
before riding.
15) Passengers Handholds
(If Equipped)
Commander Grand Tourer models
The handholds can be set at three dif-
ferent positions:
mmo2009-004-019
LOW
mmo2009-004-020
HIGH
62
______________