EasyManua.ls Logo

BRP Lynx Commander 600 E-TEC - Maintenance Schedule (4-Stroke)

BRP Lynx Commander 600 E-TEC
181 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE SCHEDULE (4-STROKE)
NOTE: The maintenance schedule does n ot exempt the pre-ride inspection.
WARNING
Failure to properly maintain the vehicle according to the maintenance
schedule and procedures can make it unsafe to operate.
EVERY 1 500 KM (1,000 MI)
Models with chaincase: Adjust drive chain
Models with chaincase: Check chaincase oil level
DRIVE
SYSTEM
Models with gearbox: Check oil level
EVERY 3 000 KM (2,000 MI) OR 1 YEAR
(WHICHEVER COMES FIRST)
Inspect all heat shields
ENGINE
Inspect exhaust system and check for leaks
Visually inspect and clean drive pulley
Tighten drive pulley retaining screw to specified torque
Check driven pulley preload
Clean driven pulley
Adjust and align track
DRIVE
SYSTEM AND
BRAKE
Inspect brake hose, pads and disk
STEERING
SYSTEM
Inspect steering mechanism
Inspect front suspension
Inspect rear suspension and stopper strap.
Lubricate front and re ar suspension whe never the vehicle is used in wet
conditions (wet snow, rain, puddles)
Check ski leg bushing an d bearing. R
eplace if needed.
SUSPENSION
All models with T/A shocks, oil change / service
EVERY 6 000 KM (4,000 MI) OR AT PRE-SEASON
(WHICHEVER COMES FIRST)
ENGINE
Change engine oil and filter
100
______________

Table of Contents

Related product manuals