BRP Lynx Commander 600 E-TEC - CONTROLS, INSTRUMENTS and EQUIPMENT (ContD); 7 Multifunction Switch

CONTROLS, INSTRUMENTS AND EQUIPMENT
mmo2016-008-201_a
ON POSITION
All operators of the snowmobile
should familiarize themselves with the
function of the emergency engine stop
switch by using it several times on first
outing and whenever stopping the en-
gine thereafter. This engine stopping
procedure will become a reflex and will
prepare operators for emergency situ-
ations requiring its use.
WARNING
If the switch has been used in an
emergency caused by a suspected
malfunction, the source of the mal-
function should be determined
and corrected before restarting
engine. See an authorized Lynx
dealer for servicing.
7) Multifunction Switch
Multifunction sw itc h is located on the
LH side of handlebar.
fmo2014-003-003_a
1. Start button
2. Headlights dimmer switch
3. Heated grips
4. Heated throttle lever
5. Mode/set button
Start Button
Press to start engine. Refer to
ENGINE
STARTING PROCEDURE
in the OPER-
ATING INSTRUCTIONS
.
Headlights Dimmer Switch
Press to select HI or LOW beam.
Lights are automatically ON when the
engine is running.
Heated Grips and Throttle Lever
Switch
E-TEC
NOTE: Under 1900 RPM, heated grips
or throttle lever w ill be limited at 50%.
All Models
Depress switch as required to select
heating intensity to keep your hands at
a comfortable temperature.
_______________
47