EasyManua.ls Logo

BRP Lynx Commander 600 E-TEC - TRACTION ENHANCING PRODUCTS

BRP Lynx Commander 600 E-TEC
181 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TRACTION ENHANCING PRODUCTS
NOTE: This section is applicable to
snowmobiles equipped with a factory
installed track that has been approved
by BRP for special studs installation.
WARNING
Never stud a track that has not
been approved for studs. Ap-
proved tracks can be identified by
a stud symbol (see illustration be-
low) molded into the track surface.
Installing studs on an unapproved
track could increase the risk of the
track tearing or severing.
A00A8KA
12
TRACK SYMBOLS
1. Approved
2. NOT Approved
WARNING
Use only the BRP approved type
stud for these Lynx snowmobiles.
DO NOT EVER use conventional
studs as the track thickness is thin-
ner then other standard tracks.
The stud could tear off of track and
separate from vehicle. See an au-
thorized Lynx dealer for current
specific studding availabil
ity and
applications.
Using traction enhancing p
roducts
such as, more aggressive ski carbide
runners and/or studs on your snow-
mobile will change its
behavior, par-
ticularly in terms of manoeuv ra bility,
acceleration, and braking.
Using traction enhancing products
gives a better grip on packed snow
and ice, but has no no
ticeable effect
on soft snow. For this reason, driving
a snowmobile equipped with traction
enhancing products requires a c ertain
adaptation period. If your snowmobile
is equipped with traction enhancing
products, be sure to take plenty of time
to get used to the way it handles when
turning, accelerating, and braking.
Also, always check local regulations
concerning the use of traction enhanc-
ing products on snowmobiles. Always
drive your snowmobile in a responsible
manner, respecting the environment
and other people’s property.
Manoeuvrability
Using traction enhancing products
such as, more aggressive ski carbide
runners a nd/or studs m akes the snow -
mobile grip the ground better at both
the front and at the rear. The use of
carbide runners is therefore required
to give the skis a better grip, so that the
front and rear of the snowmobile are
in balance. While off-the-shelf carbide
ski runners are adequate, they don’t
necessarily give you optimal control,
since that depends on your personal
preferences, your riding style, and how
your suspension is adjusted.
WARNING
If the front and rear of the snow-
mobile are out of balance due to an
incorrect combination of traction
enhancing products, the snow-
mobile may tend to oversteer or
understeer, which could lead to a
loss of control.
Oversteering
In certain conditions, using more ag-
gressive ski carbide runners without
studs on the rear track coul
d make the
snowmobile prone to oversteering,
see illustration.
26
_______
SAFETY I
NFORMATION
________

Table of Contents

Related product manuals