Transport, Packaging and Storage
14 E1400011_1_001
Do not Damage Air-tight
Packaging
The packaging is air-tight. Damage to the
barrier layer may render the contents
unusable.
Do not pierce.
Do not use sharp objects to open.
Component Sensitive to
Electrostatic Charge
The packaging contains components which
are sensitive to an electrostatic charge.
Only allow packaging to be opened by trained
personnel.
Establish potential equalisation before
opening.
Protect from Heat Protect packages against heat and direct
sunlight.
Protect from Heat and
Radioactive Sources
Protect packages against heat, direct sunlight
and radioactive sources.
Table3.1: Symbols on the Packaging
3.2 Inspection at Delivery
Upon receipt, immediately inspect the delivery for completeness and transport damage.
Proceed as follows in the event of externally apparent transport damage:
• Do not accept the delivery, or only accept it subject to reservation.
• Note the extent of the damage on the transport documentation or the shipper's delivery
note.
• Initiate complaint procedures.
Note: Issue a complaint in respect to each defect immediately following detection. Damage
compensation claims can only be asserted within the applicable complaint deadlines.
3.3 Packaging
About Packaging
The individual packages are packaged in accordance with anticipated transport conditions.
Only environmentally friendly materials have been used in the packaging.
The packaging is intended to protect the individual components from transport damage,
corrosion and other damage prior to assembly. Therefore do not destroy the packaging and
only remove it shortly before assembly.
It is recommended to store the packaging for later use in the event that you need to return the
unit to Bruker.
Handling Packaging Materials
Dispose of packaging material in accordance with the relevant applicable legal requirements
and local regulations (see Dismantling and Disposal [}67]).
To Next Page
Loading...
Need help?
General
