Safety
E1400011_1_001
7
2 Safety
This manual contains notices which should be observed to ensure your own personal safety
as well as to protect the spectrometer and the connected equipment.
2.1 Intended Use
The minispec is a pulsed time-domain NMR analyzer used for the monitoring of NMR
receptive nuclei, particularly hydrogen, fluorine and phosphorus, but sometimes other nuclei.
This product is intended to be used solely for measurements on industrial samples. The
minispec has not been tested for compliance with regulatory agencies for human subject
exposure to radio frequency irradiation. Although no indication that any danger exists, under
no circumstance is this product intended for measurements on humans.
2.2 Qualified Personnel
The minispec may only be set up and operated in conjunction with the instructions in this
manual. Only qualified personnel should be allowed to work on this equipment. The primary
installation, maintenance and repair of the minispec may only be carried out by personnel
which are authorized by BRUKER.
All repairs, adjustments and alignments performed on any components of the minispec must
be carried out strictly in accordance with the established safety practices and standards of
the country where the instrument is installed.
2.3 Correct Usage
This device and its components may only be used in the way discussed with a BRUKER
specialist and in connection with devices or components from other manufacturers which
have been approved or recommended by BRUKER.
Note: This product can only function correctly and safely if it is transported, stored, set up
and installed correctly, and operated and maintained as recommended by BRUKER.
To Next Page
Loading...
Need help?
General
