Running the minispec mq20 Toothpaste Analyzer
E1400912_1_001 45
Moreover the minispec can be configured, please see the next screenshot. The minispec
serial number as well as software installation path can be set. However – if the software runs
for instance the Daily Check successfully, then there is no need to do any modification on
those settings.
Calibration settings can be specified in minispec Plus, for instance the number of calibration
samples to be measured as a minimum – despite the below example, we recommend a
minimum of 3 calibration samples per parameter to be analyzed. This is also the default
setting in minispec Plus software.
To Next Page
Loading...
