Electrical components
Replacing the transistor regulator
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 16 – 3
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
16.2 Replacing the transistor regulator
Note:
This action requires access to TruckCom!
1. Remove the inspection cover.
2. Cut off the cable ties of the cable duct on the transistor regulator
side.
3. Disconnect the connectors (A) from the connector bracket.
4. Loosen the screws (D) and fold away the connector bracket.
5. Disconnect all cables and connectors from the transistor regulator.
6. Loosen the mounting nuts (B) of the back plate.
7. Remove the transistor regulator.
Take out the back plate starting from the upper edge, then turn it in
the truck's drive wheel direction to remove it from the truck.
8. Unscrew the transistor regulator from the back plate (C).
Assembly is done in reverse.
After installation of the new transistor regulator, the truck will display
error code 2.004.
A
D
https://www.besttruckmanuals.com/
To Next Page
Loading...
