BTECH GMRS-V2 - Page 67

VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
61
6
ABR - Display
Illumination
Time
OFF [0] - 1 - 2 - 3 - 4 - 5 - 6 –
7 - 8 - 9 - 10
Time-out for the LCD backlight. (In seconds)
7
TDR - Dual
Watch, Dual
Reception
OFF [0] - ON [1]
Monitor [A] and [B] at the same time. The display with
the most recent activity ([A] or [B]) becomes the
selected display.
When TDR is set to ON, an 'S' is indicated in the status
display --- TDR should be set to OFF when manually
programming --- TDR is inhibited while scanning is in
operation
8
BEEP -
Keypad Beep
OFF [0] - ON [1]
Allows audible confirmation of a key press
9
TOT -
Transmission
Time-out-
Timer
in 15 second steps
15, 30, 45, … 600
The red TX LED begins to flash
10 seconds before the timeout
limit is reached
This feature provides a safety switch, which limits
transmission time to a programmed value. This will
promote battery conservation by not allowing you to
make excessively long transmissions, and in the event of
a stuck PTT switch (perhaps if the radio or a Speaker/Mic
is wedged between car seats) it can prevent interference
to other users as well as battery depletion.
10
R-DCS -
Receiver DCS
OFF [0] - see DCS Table in
Appendix C
Mutes the speaker of the transceiver in the absence of a
specific low level digital signal. If the station you are
listening to does not transmit this specific signal, you will
not hear anything.