BTECH GMRS-V2 - Page 73

VISIT BAOFENGTECH.COM AND MIKLOR.COM FOR DOWNLOADS AND HELP
67
34
TDR-AB -
Transmit
selection
while in Dual
Watch mode
OFF [0] - A [1] - B [2]
When enabled, priority is returned to selected display
once the signal in the other display disappears.
35
STE - Squelch
Tail
Elimination
OFF [0] - ON [1]
This function is used eliminate squelch tail noise
between BTECH handhelds that are communicating
directly (no repeater). Reception of a 55 Hz or 134.4 Hz
tone mutes the audio long enough to prevent hearing
any squelch tail noise.
36
RP-STE -
Squelch Tail
Elimination
OFF [0] - 1 - 10
This function is used eliminate squelch tail noise when
communicating through a repeater.
37
RPT-RL -
Delay the
squelch tail
of repeater
OFF [0] - 1 - 10
Delay the Tail Tone of Repeater (X100 milliseconds)
38
PONMSG -
Power on
Message
FULL [0]: Performs an LCD screen
test at power-on
MSG [1]: Displays a 2-line power-on
message
Controls the behavior of the display when the
transceiver is turned on. MSG text set with PC.
39
ROGER -
Roger Beep
OFF [0] - ON [1]
Sends an end-of-transmission tone to indicate to other
stations that the transmission has ended.