Standard functions
6
Logamatic 4211 - Subject to technical modifications.
17
6 Standard functions
In this chapter you will find information about the standard functions of the MEC2
programming unit and their use. The standard functions are:
– Selecting the operating mode
– Setting the room temperature
– Setting the DHW temperature
– Heating DHW once
6.1 Simple operation
The standard functions are controlled by pressing one of the keys on the
"Standard function" keypad or by turning the rotary selector.
Example: Adjusting the room temperature for day mode
Press "Day mode" to select the standard heating mode (day mode). The LED of
the "Day mode" key illuminates; day mode is enabled.
Set the required room temperature by turning the rotary selector. (Condition: For
this, the programming unit flap must be closed.)
The display shows the set value.
Tag Zeit Temp
Urlaub Auswahl So/Wi
Anzeige Heizkreis Zurück
AUT
USER INFORMATION
If your heating system is equipped with several heating circuits, first select the
correct heating circuit (Æ Chapter 7.6). Only then can you select the operating
mode and room temperature.
USER INFORMATION
The following MEC2 displays only describe the possible displays:
– of the ZM422 module (standard equipment level)
– of the most frequently used FM442 module (accessory)