Buderus Logamatic 4211 User Manual

Standard functions
6
Logamatic 4211 - Subject to technical modifications.
20
6.4 Setting the room temperature
With the flap closed you can adjust the room temperature with the rotary
selector. With the flap open, also press "Day mode" or "Night mode".
With the rotary selector, you can select the room temperature in degree steps
between 11 °C (day), or 2 °C (night), and 30 °C. The set temperature is displayed
via an LED next to the rotary selector. For temperatures below 15 °C or above
25 °C, the "–" or "+" LED illuminates.
The factory setting for the day room temperature is 21 °C.
The factory setting for the night room temperature is 17 °C.
Any adjustment applies to all heating circuits assigned to the MEC2
programming unit (Æ Chapter 7.7).
6.4.1 For the current operating mode
You are currently in automatic "Day mode" and would like to alter the room
temperature.
(Condition: For this, the programming unit flap must be closed.)
Turn the rotary selector to the required day room temperature (here: "23°C").
The day room temperature is now adjusted to 23 °C. The selected permanent
display will then appear again.
Tag Zeit Temp
Urlaub Auswahl So/Wi
Anzeige Heizkreis Zurück
AUT
AUT
USER INFORMATION
The set room temperature applies to the currently enabled heating mode,
i.e. day or night mode. You can recognise the currently enabled heating mode
because the green LED illuminates.
Set room
Automatic day
23°C

Buderus Logamatic 4211 Specifications

General

Brand	Buderus
Model	Logamatic 4211
Category	Control Unit
Language	English