Buderus Logamatic 4211 User Manual

Extended functions
7
Logamatic 4211 - Subject to technical modifications.
26
7.2 Controlling the extended functions
The extended functions provide access to a further control level. At this level,
proceed according to the "Push and turn" principle. The control procedure is
always similar:
z Open flap.
Hold the required key down, e.g. the "Time" key, and simultaneously turn the
rotary selector.
By turning the rotary selector you modify the values that flash on the display.
Release key. Modified values are saved.
7.3 Displaying operating values
You can display and control the various operating values of the boiler, the
selected heating circuit and the system.
Only the operating values of the selected heating circuit, e.g. heating circuit 0,
are displayed (Æ Chapter 7.6).
z Open flap.
Turn the rotary selector clockwise without pressing any other key.
Subject to the modules, various of the following operating displays can be called
up:
– Burner and Hours run
– Actual heating circuit room temperature
– Set heating circuit room temperature
– Heating circuit operating state
– Actual heating circuit flow temperature
– Actual DHW temperature*
– Set DHW temperature*
– DHW operating mode*
– Operating state – DHW circulation pump and cylinder primary pump*
* Only if a DHW module has been installed.
+
"Back" key = Exit menu.
AUT
Heating circ. 0
20°C
Set room

Buderus Logamatic 4211 Specifications

General

Brand	Buderus
Model	Logamatic 4211
Category	Control Unit
Language	English