Additional programming options
8
Logamatic 4211 - Subject to technical modifications.
62
8.3 Creating a new DHW program
You may operate DHW heating either according to the factory settings
"Program select. by heat. circs" or according to your own switching program
"Program select. own DHW".
If DHW is to be heated independently of the heating circuits, you can enter your
own new DHW program as follows:
Example:
On all weekdays DHW should be heated from 06:30 until 09:00.
z Select a heating circuit (Æ Chapter 7.6).
(here: "DHW")
z Select a program for the heating circuit "DHW" (Æ Chapter 7.10).
(here: "Program select. new")
The display shows the blank screen "New switch.point" for the new switching
point.
z Enter the switching points (Æ Chapter 8.2).
DHW heating will now operate according to your "Own program DHW". You can
call up your new "Own program DHW" by pressing "Prog" and turning the rotary
selector (Æ Chapter 7.6).
USER INFORMATION
With the factory setting "Program select. by heat. circs", DHW heating begins
30 minutes prior to the first switching point of all heating circuits associated with
this control unit, and ends when the last heating circuit is stopped.
USER INFORMATION
Only after all three details (day/time/temperature) have been defined for the
new switching point will it be automatically saved under "Own program DHW",
and the heating circuit selection "DHW". The saving process is not shown on
the display. The display shows the blank screen "New switch.point" for the next
switching point. Repeat this process for all required switching points.
To Next Page
Loading...
Need help?
General
