Buderus Logamatic 4211 User Manual

Extended functions
7
Logamatic 4211 - Subject to technical modifications.
42
7.14 Setting the DHW operating mode
This allows you to change the DHW temperature in the DHW cylinder.
z Open flap.
Hold down "Heating circ." and select "DHW" with the rotary selector.
Release "Heating circuit" key.
The permanent display will then appear again.
Select one of the following operating modes for DHW:
– "Const. operation"
The water inside the DHW cylinder is constantly maintained at the set
temperature.
Press "Day mode" to select constant operation. After approximately three
seconds, the permanent display will appear again.
– "Automatic"
30 minutes before the first heating circuit is started, the boiler heats the
DHW cylinder to the set temperature, and stops when the last heating circuit
is switched off (factory setting). Alternatively, you can enter your own DHW
program (Æ Chapter 8.3).
Press "Automatic" to select automatic mode. After approximately three seconds,
the permanent display will appear again.
– "DHW OFF"
DHW heating is switched off. By pressing "DHW", you will switch heating on
for the duration of "DHW heating once".
Press "Night mode" to stop DHW heating. After approximately three seconds,
the permanent display will appear again.
AUT
AUT
+
Heat. circ. sel.
DHW
Actual room
Outside temp.
0°C
19.5°C
AUT

Buderus Logamatic 4211 Specifications

General

Brand	Buderus
Model	Logamatic 4211
Category	Control Unit
Language	English