Standard functions
6
Logamatic 4211 - Subject to technical modifications.
18
Subject to the way your heating contractor has configured your system, one or
more MEC2 displays may not appear, although the above modules are fitted in
your control unit.
Detailed descriptions of MEC2 displays for other modules are included in the
corresponding module documentation.
6.2 Permanent display
There are two different permanent displays. Either one of the factory-set
permanent displays is shown, subject to whether the MEC2 is fitted in the control
unit or is installed as a wall mounted unit.
Factory-set permanent display, if the MEC2 is fitted in the control unit.
Factory-set permanent display, if the MEC2 is installed as a wall mounted unit.
6.3 Selecting the operating mode
You can operate the MEC2 programming unit in two ways:
– In automatic mode
– In manual mode
Automatic mode
Generally, homes are heated less at night than during the day. With the MEC2
programming unit you don't need to adjust the thermostatic radiator valves
before bedtime or in the morning. The automatic changeover of the MEC2
programming unit does this for you. It changes over between day mode
(standard mode) and night mode (setback mode).
The times at which your heating system changes from day to night mode – and
vice-versa – are factory-set via standard programs (Æ Chapter 7.10). However,
you or your heating contractor can modify these settings (Æ Chapter 7.12).
Manual mode
For example, if you want to heat longer in the evening or not quite as early in the
morning, you can also select day and night mode manually (Æ Chapter 6.3.2).
You can also use manual mode to heat on cooler days when the system
operates in summer mode.
To Next Page
Loading...
Need help?
General
