Extended functions
7
Logamatic 4211 - Subject to technical modifications.
47
7.18 Setting the party function
This function only applies to heating circuits to which the MEC2 has been
assigned as a remote control unit ("MEC heat. circ.") All heating circuits without
an MEC2 continue to operate normally.
Enter the length of time the system should only heat to the preset room
temperature.
Example:
You have a party and want to heat for the next four hours to the preset room
temperature.
Hold down "Day mode", and simultaneously open the flap of the MEC2.
"Party function" is enabled. Hold "Day mode" down, and turn the rotary selector
until the required number of hours is displayed (here: "4").
The display shows the party function together with the set number of hours.
Release "Day mode" key.
The party function starts immediately. After the set time has expired, the heating
system returns to automatic heating mode.
If you want to cancel the party function, call up party function as described above
and turn the rotary selector to "0".
7.19 Setting the pause function
This function only applies to heating circuits to which the MEC2 has been
assigned as a remote control unit ("MEC heat. circ."). All heating circuits without
an MEC2 continue to operate normally.
Enter the length of time the system should heat to the preset room temperature.
Example:
You are about to leave your home for three hours and would like to heat less
whilst you are away.
Hold down "Night mode", and simultaneously open the flap of the MEC2. The
pause function is enabled. Continue to hold down "Night mode", and turn the
rotary selector until the required number of hours is displayed (here: "3").
The display shows the pause function together with the set number of hours.
Release "Night mode" key.
The pause function starts immediately. After the set time has expired, the
heating system returns to automatic heating mode.
If you want to cancel the pause function, call up pause function as described
above and turn the rotary selector to "0".
To Next Page
Loading...
Need help?
General
