Operation with the user menu
Logamatic EMS – 6 720 801 386 2011/05
28
5
Designations of the heating circuits in the example in Fig. 2
When you make adjustments to a particular heating circuit, first select the appropriate heating
circuit. A list of designations as shown in table 12 is available for selection.
If the heating specialist has set this accordingly, different temperatures in the heating circuits are
possible (Æ Tab. 12, [1] b), even with the RC35 programming unit without remote programmer. In
this case, the room temperatures for the separate heating circuit can be set via the user menu
(Æ page 37).
fig. 2 For heating circuit 1+2:
Designation of the heating
circuits on the display
How to set the room
temperature
[1] same room temperature
(basic setting)
HK1+HK2 = RC35 heating
circuits
1)
1) If no other heating circuits, such as for example DHW, are available, the selection of the heating circuit is
not required.
Page 14 – 16
[1] different room temperature
possible
2)
2) Here: setting by heating specialist HK 1 = none, HK 2 = RC35
HK1 = heating circuit 1
HK2 = RC35 heating circuits
HK1: page 16 or 37
HK2: page 14 – 16
[2] Different room temperatures
possible
HK1 = heating circuit 1
HK2 = RC35 heating circuits
HK1: via RC2x
HK2: page 14 – 16
Table 12 Designations of the heating circuits in the example in Fig. 2, page 27
To Next Page
Loading...
