Buffalo TeraStation - Page 121

TeraStation User Manual 120
Port Trunking
Click [Modify
Settings] to
change settings.
Port Trunking Enable Port Trunking to use two Ethernet connections to the TeraStation. The
following congurations are available:
• [O] : Do not use port trunking.
• [Round-robin policy] : Sets a round-robin policy for fault tolerance and load
balancing.
• [Active-backup policy] : Sets an active-backup policy for fault tolerance.
• [XOR policy] : Sets an XOR (exclusive-or) policy for fault tolerance and load
balancing.
• [Broadcast policy] : Sets a broadcast policy for fault tolerance.
• [Dynamic link aggregation] : Sets an IEEE 802.3ad dynamic link aggregation policy.
• [Adaptive transmit load balancing (TLB)] : Sets a Transmit Load Balancing (TLB)
policy for fault tolerance and load balancing.
Workgroup/
Domain
Click [Modify
Settings] to
change settings.
Authentication Method Select the method to join the network ([Workgroup], [NT Domain], or [Active
Directory]). [Workgroup] is the default. Networking knowledge is required to
congure other methods. Consult your network administrator for details.
Workgroup Name To join a workgroup, enter the name of your workgroup.
* You can enter up to 23 bytes(UTF-8).
* Alphanumeric characters, multi-byte characters, -(hyphen), _(underscore), and
.(dot) may be used.
* Do not use a symbol as the rst character.
WINS Server IP Address Enter the IP address of your WINS server to use WINS Server.
NT Domain Name Enter [NT Domain Name] to use [NT Domain] as the method to join the network.
* You can enter up to 23 bytes(UTF-8).
* Alphanumeric characters, multi-byte characters, -(hyphen), _(underscore), and
.(dot) may be used.
* Do not use a symbol as the rst character.
NT Domain Controller
Name
Enter [NT Domain Controller Name] to use [NT Domain] as a method to join
the network. Register the computer account which has the same name as the
TeraStation to the Domain Controller.
* You can enter up to 63 bytes(UTF-8). Do not use multi-byte characters.
* Alphanumeric characters, -(hyphen), and _(underscore) may be used.
* Do not use a symbol as the rst character.
Active Directory
Domain Name
(NetBIOS Name)
Enter [Active Directory Domain Name (NetBIOS Name)] to use [Active Directory] as a
method to join the network.
* You can enter up to 23 bytes(UTF-8).
* Alphanumeric characters, multi-byte characters, -(hyphen), _(underscore), and
.(dot) may be used.
* Do not use a symbol as the rst character.
Active Directory
Domain Name (DNS/
Realm Name)
Enter [Active Directory Domain Name (DNS/Realm Name)] when selecting [Active
Directory] as a method to join the network.
* You can enter up to 255 bytes(UTF-8). Do not use multi-byte characters.
* Alphanumeric characters, -(hyphen), _(underscore), and .(dot) may be used.
Administrator
Password
Enter [Administrator Password].
* This must be entered if [NT Domain] or [Active Directory] is selected for
[Authentication Method].
* You can enter up to 256 bytes(UTF-8). Do not use multi-byte characters.
* Alphanumeric characters, -(hyphen), and _(underscore) may be used.
* Do not use a symbol as the rst character.