Burkert 8041 - Page 38

38
Adjustment and commissioning
A
→ Briey press push button.
To calibrate automatically
→ Press and hold the push
button until...
To select the calibration of the
other parameter
B
→ Wait for 10s.
To go back to the Read mode
C
NO
Go back to Read mode
without conrming the
selection displayed.
Calibration in progress
Go back to Read mode.
.....
End of calibration: red LED
goes o?
YES
Zero point stored.
Red LED ashes briey
twice: zero point has not
been calibrated.
→ Briey press push
button
Go back to Read mode
using the zero point of the
previous calibration.
→ Check that the cali-
bration instructions are
respected (see beginning
chapter9.7).
→ Restart calibration
of the zero ow
point.
...bargraph goes back to step1,
Fig.27
Fig.28: Calibrationofthezeroowpoint,part2
english
Type 8041