Burkert 8041 - Page 46

46
Adjustment and commissioning
NO
See general con-
guration diagram,
chapter9.3
Device in Read mode?
.....
YES
A
To view low switching threshold
1 2 3 4 5 6 7 8 910
0 100% FS
Bargraph shows current low switching threshold,
24% in the example (by default = FS)
→ Press push button twice briey
To view high switching threshold
→ Press push button three times briey
1 2 3 4 5 6 7 8 910
0
100% FS
Bargraph shows current high switching threshold,
82% in the example (by default = FS)
To set the factors of ten for the low
switching threshold
→ Press and hold the push
button.
After 2s, device is in Parameterizing mode:
B
After 2s, device is in Parameterizing mode:
Notation convention:
.....
Green LED state
Red LED state
FS=Full scale
To set the factors of ten for the high
switching threshold
Fig.40: Settingtherelayswitchingthresholds,part1
english
Type 8041